Routing MCQ

Q1) Which three situations might require multiple routing protocols in a network? (Choose three.)
A) when a new Layer 2-only switch is added to the network
B) when you are migrating from one routing protocol to another
C) when you are using routers from multiple vendors
D) when there are host-based routers from multiple vendors

Q2) Which two routing protocols can be redistributed into OSPF by a Cisco router? (Choose two.)
A) IP EIGRP
B) Appletalk EIGRP
C) RIPv2
D) IPX RIP

Q3) Which is a reason for avoiding doing route redistribution on two routers between the same two routing domains?
A) higher cost of two routers
B) routing feedback
C) Cisco IOS incompatibility
D) not possible to use two routers

Q4) The subnet keyword is required when you are redistributing subnet routes into which routing protocol?
A) OSPF
B) RIP
C) EIGRP
D) IS-IS

Q5) Which two actions does issuing the passive-interface command prevent? (Choose two.)
A) prevents routing updates from being sent out an interface but not from being received on an interface
B) prevents routing updates from being sent out an interface and also from being received on an interface
C) prevents link-state protocols and EIGRP from sending hellos out the interface
D) prevents the exchange of routing updates only, not hellos

Q6) Which statement does not describe route map operation?
A) Routes maps use a top-down processing scheme.
B) Route maps use match and set logic to match a metric and then set which route is redistributed
C) Route maps are line-numbered for easier editing.
D) Route maps use an implicit deny at the bottom of the map, just like access lists.

Q7) When you are configuring a route map, you must define a map tag. How is a map tag used?
A) to tag a route in a set command
B) to match on a tagged route in a match command
C) to deny routes from being redistributed
D) to give a name to the route map

Q8) What does administrative distance rank?
A) metrics
B) sources of routing information
C) router reliability
D) best paths

Q9) DHCP is structured to use which two well-known UDP ports? (Choose two)
A) BOOTPS
B) TFTP
C) DNS
D) BOOTP

Q10) A request for address assignment is initiated by which device?
A) client
B) relay agent
C) router
D) DHCP server

Q11) What is the purpose of the Cisco IOS global command ip dhcp pool [pool name]?
A) to define the inside global address pool for NAT
B) to define a range of IP addresses to be assigned by the router acting as a DHCP server
C) to define exceptions to the IP addresses to be assigned
D) to enable global route summarization